Nextodi ND2700 Manual de usuario descargar pdf (Pagina 15)

The Nexto-eXtreme is sometimes delivered with a hard drive installed. If a drive is not

included, or if the drive fails, or if you wish to install another hard drive, you may do so. You

need a 2.5" Serial ATA hard drive; its installation height must not exceed 9.5mm. Supported

hard drive capacity is up to 2,000GB (two terabytes.)

Nexto-eXtreme does not support PATA or IDE hard drives.

12. Installing and Formatting a Hard Drive

Disconnect all cables from the Nexto-eXtreme.

●Remove the cover on the lower side.



●Insert a 2.5" SATA hard drive.

The protective film must be placed between

the circuit board and the hard drive.

●Make sure that the pins of the hard drive are

inserted securely into the socket board inside

the case.

●Put the cover on again. Be sure to put the cover on

the right way; the larger foam insert on the inside of

the cover faces in the direction of the power

socket/USB port.

● Fasten the cover with the four small screws. A

suitable screwdriver is included.

● The hard drive must then be formatted.

25 Installing and Formatting a Hard Drive Installing and Formatting a Hard Drive 26

Formatting the Hard Drive

The hard drive in the Nexto-eXtreme must be formatted as file system "FAT32." Only the first

partition can be used by the Nexto-eXtreme.

In Windows XP and Vista Systems, hard drives are formatted with the file system

"NTFS"; no "FAT32" format option is available. If you are using a drive that was

previously formatted by a NTFS system, you must reformat it with the

Nexto-eXtreme formatting function explained in the section, below, entitled

“Using a Hard Drive Which is Already Formatted.”. For Macintosh OS, although

its internal hard drives are formatted with the HFS+ (Mac OS Extended,) FAT32 is

recognized by the MAC OS.

To Format a New Hard Drive

The Nexto-eXtreme must not be connected to the computer via USB or eSATA. Remove any

memory cards or USB devices from the Nexto-eXtreme.

● When the Nexto-eXtreme is turned on after installing a new hard drive, an error message

will appear ("Disk Format Error"), indicating that the drive is not formatted (new drives are

usually delivered non-partitioned and non-formatted).

● To format the drive, use a (L)ong stroke (press and hold the key for more than 1 second).

Nexto-eXtreme will format the new hard drive.

Confirm HDD

Format !

▶ ▶

1 2 ... 10 11 12 13 14 15 16 17

Comentarios a estos manuales

Sin comentarios

Nextodi ND2700 Manual de usuario Pagina 15

Comentarios a estos manuales